|
CZ Scorpion EVO III Extended Magazine Release - Black - $44.99 (Shooters Element) | Added: 2/7/2017 (88 months ago)
|
| This drop in extended magazine release for your CZ Scorpion EVO3 improves on the factory magazine release and gives you an extended paddle under the trigger guard. | Current Deal
|
|
| 2020 views | Comments | ||
|
CZ Scorpion Flat Trigger - Black (No Markings) - $34.99 (Shooters Element) | Updated: 2/7/2017 (88 months ago)
|
| The CZ Scorpion EVO III is a great pistol caliber carbine/pistol. However there's a few improvements most shooters see the need for after shooting it for the first time. Mainly the trigger, at 10lbs of pull weight or higher it's a bit to overcome for even the most experienced of shooter. However, Shooters Element has developed a solution for the problem with our enhanced flat trigger. With the improved ergonomics and add leverage of the trigger we are seeing anywhere from a 7 to 10 % reduction in pull weight with just the trigger, we're also noticing an improvement in the second most common issue on the gun, the strong side safety digging into a shooters hand. Because of the design, shooters will find it more natural to place the pad of their finger (between the first knuckle and tip) on the trigger for a more steady pull and constant pull allowing your trigger finger to curve out and away from the safety rather than ride along it. | Current Deal
|
|
| 2041 views | Comments | ||
|
CZ Scorpion EVO III Flat Trigger - Red - $34.99 (Shooters Element) | Updated: 4/5/2016 (98 months ago)
|
| The CZ Scorpion EVO III is a great pistol caliber carbine/pistol. However there's a few improvements most shooters see the need for after shooting it for the first time. Mainly the trigger, at 10lbs of pull weight or higher it's a bit to overcome for even the most experienced of shooter. However, Shooters Element has developed a solution for the problem with our enhanced flat trigger. | Current Deal
|
|
| 1972 views | Comments | ||
|
CZ Scorpion Trigger Case Retaining Screw - $2.00 (Shooters Element) | Added: 12/21/2015 (101 months ago)
|
| Replacement for the factory case retaining screw on the CZ Scorpion Evo III. Part #48 often gets stripped out while changing internal components or routine cleaning. It's highly suggested to buy this part when replacing the trigger mechanism due the numerous reports and stories of component failure. | Current Deal
|
|
| 2249 views | Comments | ||
|
CZ Scorpion EVO 3 S1 Reduced Weight Trigger Spring Kit - $8.95 (Shooters Element) | Added: 12/21/2015 (101 months ago)
|
| The HB Industry spring kit provides a 5.5lb trigger pull (down from 9.0+ lbs factory trigger). Simply remove your factory trigger and disconnector springs (#63 and #50 respectively on the factory parts diagram) and replace them with our application specific trigger and disconnector springs. Both springs in the kit must be used together. Gunsmith installation is recommended, but not required. | Current Deal
|
|
| 2075 views | Comments | ||
